Comprehensive Calibration Maps

The module offers a wide array of editable maps categorized by system:

• Air & Load: Air charge efficiency for High/Low VTEC, airmass flow through the throttle body, exhaust back pressure, and load limitation for both VTEC modes.

• Camshaft Control: Target camshaft angles and camshaft angles at WOT for both High and Low VTEC.

• Ignition & Knock: Spark advance (EGR dependent or torque-reduction focused), dwell time, knock sensitivity, and spark advance limitation for knocking in both VTEC modes.

• Fuel & Lambda: Target lambda (full load, closed loop, and limits), MAP fuel for High/Low VTEC, and injector scaling.

• Idle & Rev Limits: Desired idle speed (standard and after-start), engine speed limitation, and overrun injector restart/recovery RPM.

• Throttle & Sensors: Throttle valve position linearization, driving force, MAF sensor scaling, and lambda sensor conversion.

Supported Software (SW) List

This module supports an extensive range of Honda part numbers, including:

• 62A/62B Series: 37805-62A-Q510, 37805-62A-T520, 37805-62B-N010, 37805-62B-N710.

• 62C/62T Series: 37805-62C-M520, 37805-62C-M710, 37805-62C-M810, 37805-62T-M510.

• Specialized Series: 37805-6FJ-K610, 37805-6HA-J510, 37805-6HC-N510, 37805-6HP-Z510, 37805-6KR-K610, 37805-6X1-U510.

Critical Limitations & Requirements

• No Support: This module does not support vehicle speed (VMAX) limitation editing or DTC (Diagnostic Trouble Code) masks.

• Security: A BitSoftware Senselock USB protection key is mandatory to use this module.

• Functionality: BitEdit is strictly an editor; it does not perform ECU reading, writing, or checksum correction, which requires a separate tool like BitBox.

• Processing: Due to high technical demand, urgent requests are not permitted; standard requests for new descriptions may take several days.