Core Technical Specifications

• Supported MCU: Infineon Aurix TC275T.

• Supported Filesize: 4.0 Mb.

Calibration Editing Capabilities

The module provides a comprehensive set of maps for engine management and performance tuning:

Boost and Turbo Control

• Pressure Limits: Boost limit based on atmospheric pressure and intake air temperature.

• Turbo Management: Maximum boost limit, maximum turbo position limit, and turbo position in additional modes.

• DPF Mode: Specific boost pressure and turbo position maps for DPF additional modes.

Injection and Rail Pressure

• Injection Timing: Injector time lift and time lift conversion.

• Fuel Rail: Target fuel rail pressure, maximum rail pressure limits, and rail pressure at startup.

• Start of Injection (SOI): Start of injection parameters for additional modes.

Limiters and Torque Control

• Quantity Injection Limits: Based on boost, intake air temperature, and mass air flow (MAF).

• Torque Limiters: Highly detailed limits based on atmospheric pressure, coolant temperature, clutch stroke, exhaust temperature, fuel temperature, gear, and vehicle speed.

• Torque Logic: Accelerator pedal position conversion and accelerator torque position.

• Vehicle Speed: Engine speed and vehicle speed limitation.

EGR and Airflow

• Exhaust Gas Recirculation: Target EGR position, maximum position, and position per quantity injection.

• Sensors: Voltage calibrations for coolant, fuel, intake air temperature, and MAF sensors.

Diagnostics

• DTC: Diagnostic Trouble Code table for error management.

Compatibility and Requirements

Supported Software (SW) List

The following software versions are confirmed for this module:

• 93021041001_20161213

• 93031080001_20161213

• 93031084001_20161213

Hardware Needs

• A BitEdit USB security dongle is required to activate and use the module.

• The module is frequently paired with BitBox for the reading and writing of these specific ECUs.